CTRCB. Serial TTL to RCBUS Converter.

CURCB is used to adapt an RCBus interface to Serial TTL (38400b).

In this way you can connect a tracker antenna like SATPRO to a dataLink from other brands, to use the Mavlink protocol in streaming.

Normally it is necessary together with CURCB and SATPRO when we use a Datalink from other brands that are not XLRS.

Functioning:

2 modes:

Boot.

Streaming & Commands.

Conections:

It has two connectors, a more robust one for power and RCBus that connects to the SATPRO PC and a stereo RCBus Jack with TTL serial that connects to the Data Link.
For its complete operation it is necessary to use the CURCB module to connect the PC via USB.

It is powered by RCBus Connector from SATPRO.

Warning: Connections must be made only with the SATPRO turned off. If not, it is possible that the SATPRO or the fuse may break.

RCBUS:

SATPRO native communications. Use a special cable with power.

Speed: 1Mb. Synchronous binary packages.

IP8:     9

Serial TTL:

Level: TTL 0v to +3.3V.

Speed: 38400b by default or 115200b if necessary.

Bandwidth: 40kb. You cannot send a streaming with more than 4kbytes/sec even if the port speed is 115200b.

Serial TTL TXRX connector connection (Data Link):

Black:  GND          Base Jack
Red:    RX    (Out) Jack Tip
White: TX    (Inp)  Half Jack

LEDs:

On, turns on when you activate the SATPRO.

TX and RX. They light up when there is data to or from the DataLink.

Manual:

• SATPRO, Tracker Antenna for UAVs, Drones and other vehicles
  • CURCB. USB interface Module.
  • CTRCB. Serial TTL interface Module.

Content:

x1 CTRCB. Serial TTL to RCBUS Converter.

x1 Cable Jack Connector to SP13 connector for SATPRO-RCBUS.

x1 Cable with MiniJack conector to RC Connector (3pins).